I was putting some 3 minute clips on the timeline & after rendering & burning to DVD, I noticed jitters only on a couple of clips. This didn't happen back when I was using Windows 2000. Is there some sort of problem in Vegas capture that would cause this occassionally? If I delete the problem clip & recapture this usually corrects the problem but at this point I wasted a DVD & 5 hours of render time. I thought at first it was the encoder/ or bit rate but I ruled that out by rendering the timeline again at a lower rate with the same problems. It almost appears that the canopus ADVC-100 is doubling a frame at times. I have a pent 4 with 512 ram, no conflicts and a SIIG firewire card. Canopus said try unlocking the video & audio switch on the box but that didn't help. I'm confused about the cause because I did a clean install of XP Pro & switched to the canopus from Hollywood dv bridge around the same time. Also this happens when the program source is from a DVD, so it's not only with VHS tape.
Jitters on capture
Jamz
wrote on 3/28/2002, 7:04 PM