Community Forums Archive

Go Back

Subject:Forcing stereo tracks to mono
Posted by: epinema
Date:1/31/2010 4:02:15 AM

Is it possible in Pro 7 to take a stereo track such as a softsynth on the bus and force it to ouput in mono for things like sub bass and possible kicks?

Subject:RE: Forcing stereo tracks to mono
Reply by: Iacobus
Date:2/2/2010 12:10:03 PM

You could bounce down the respective track with Ctrl + M and set the appropriate channels (either via a template or the "custom" button).

HTH,
Iacobus

Subject:RE: Forcing stereo tracks to mono
Reply by: epinema
Date:2/2/2010 1:04:23 PM

But there's no way to do it real time? Even by plugin means?

Subject:RE: Forcing stereo tracks to mono
Reply by: Chienworks
Date:2/2/2010 3:16:51 PM

Right-mouse-button click on the clip, choose Event clip / Channels. You can pick one channel only or combine the two into a single mono channel.

Subject:RE: Forcing stereo tracks to mono
Reply by: Iacobus
Date:2/4/2010 11:21:40 AM

I know that that some soft synths let you route a specific part of the synth to a specific output like KitCore does (which comes with ACID Pro 7).

For example, you'd right-click KitCore in the Mixer, choose "Insert/Remove KitCore Outputs" and then select from a list of stereo or mono outputs. You'd then route a specific pad to this output within KitCore itself. You can then control volume, effects, etc. without affecting the rest of the pads in KitCore.

Iacobus

Go Back