Splitting a track

Billy d wrote on 7/31/2007, 7:12 PM

How do I split a stereo track to give me two ouputs?
I want to send one stereo dry to about 80% front in 5.1 and one stereo 100% wet reverb to the rear two speakers.

Comments

pwppch wrote on 8/1/2007, 10:35 AM

- Set up an Assignable FX with your reverb of choice.
- Route this FX Bus to the master.
- Set the reverb up to only output the wet signal.
- On the track, send the track to the FX bus.
- The main output of the track should be the master
- Adjust the track pan to control the "80%" front
- Adjust the pan of the FX bus to pan everthing to the read. You may want to turn off the speakers for the FX bus pan for the front and center.

Peter

Billy d wrote on 8/1/2007, 8:11 PM

Thankyou, that's exactly what I wanted!