Subject:rendering aux buses

Posted by: Nubs

Date:1/28/2007 3:49:10 PM

I have not been able to figure out how to include buses in the mixdown. For example, I'll add a bus that has a reverb plug-in on it. I then route the tracks I want reverb on to that bus (bus A for example). That all works fine, but when I go to mix down the song, bus A will not be included in the mixdown. Only tracks that are routed to the Master bus are mixed down.

Any help would be appreciated.

Subject:RE: rendering aux buses

Reply by: JohnnyRoy

Date:1/28/2007 4:29:06 PM

It sounds like your bus A is not routed to the Master bus. Under the A on the bus is an icon/button for routing. Make sure it's routed to same outputs on the master bus that you are using for the render.

~jr

Subject:RE: rendering aux buses

Reply by: pwppch

Date:1/28/2007 5:03:47 PM

Where is Bus A routed to?

Peter

Subject:RE: rendering aux buses

Reply by: Nubs

Date:2/5/2007 5:04:47 PM

JohnnyRoy,

You were right. I did not have the bus routed to the Master. I had looked at that tab I bet 50 times and never really noticed it there. I would normally route the bus to a mixer channel for mixes purposes.

Thanks!!