Community Forums Archive

Go Back

Subject:Help - Unable to Drag a Groove to a Track
Posted by: randygo
Date:9/1/2006 10:27:19 AM


So I sliced up the drum track for one of my songs into about 20 loops (sliced mode), which I have laid out on a track. The results are good, but I want to experiment with different grooves on the loops.

Now, when I try to drag a groove from the groove pool onto the track it displays the "not allowed" symbol. What is preventing the groove from being applied to the track?

If I copy one of the loops to a new track I am able to apply the groove there.

What attributes of my track could be disallowing the groove? Too many loops?

Thanks,

Randy

Subject:RE: Help - Unable to Drag a Groove to a Track
Reply by: Iacobus
Date:9/1/2006 10:54:00 AM

Grooves cannot be applied to Beatmapped tracks (but just about everything else). I'm guessing your drum track is a Beatmapped track?

Iacobus

Subject:RE: Help - Unable to Drag a Groove to a Track
Reply by: randygo
Date:9/1/2006 11:23:00 AM


I thought with Acid Pro 6 audio tracks were basically free-form now and could contain any sequence of one-shots, beatmapped, and loop clips in a single track.

I'll have to check when I get home, but I suppose it is possible that I have an unused beatmapped clip lurking somewhere in the track.

I will look in the clip pool for the track and see if this is the case. Perhaps the existence of a beatmapped clip in the pool, even if not used, causes this problem.

Thanks for the guidance!

Cheers,

Randy

Subject:RE: Help - Unable to Drag a Groove to a Track
Reply by: randygo
Date:9/1/2006 1:41:44 PM

mD,

Thanks for the hint! I had a beatmapped clip (unused) sitting in the clip pool, once I removed it I was able to apply grooves to the track.

Cheers,

Randy

Message last edited on9/1/2006 1:48:42 PM byrandygo.
Subject:RE: Help - Unable to Drag a Groove to a Track
Reply by: Iacobus
Date:9/4/2006 9:44:39 AM

Cool, you're welcome. :)

Iacobus

Go Back