Community Forums Archive

Go Back

Subject:Lexicon MX200
Posted by: LPClassic
Date:7/13/2006 6:35:42 AM

Hi all,

Is anyone using the Lexicon MX200 as a Vst with Acid 6.0? There is an error message that comes up saying that the MX200 usb is either disconnected or in use by another application. The manual addresses this problem, (deactivate the MX200 port or something like that) I still get error. Just curious if anyone else is using this unit and have solved this problem. I am also using a USB hub that contains control surfaces, drum pads, guitar floor boards etc. does plugging into a hub affect things in terms of the error message stating that the port may be in use by another application? With all my stuff going into a hub then to one common USB input on the computer, I was just curious. Thanks.

Don

Subject:RE: Lexicon MX200
Reply by: bnjenter
Date:7/13/2006 10:07:51 AM

I have the same problem and I'm plugged directly into the PC.

Subject:RE: Lexicon MX200
Reply by: pwppch
Date:7/13/2006 1:27:23 PM

Don't have that unit here for testing.

I would say you should try connecting directly to the PC rather than through a hub.

Peter

Subject:RE: Lexicon MX200
Reply by: LPClassic
Date:7/14/2006 8:44:27 AM

Never mind all. I worked it out, or I should say it worked itself out. I went back in and followed the directions again and suddenly things worked, where before if I followed the directions in several host programs it did not work. I will just writed it off as operator error and call it a day.

Don

Go Back