PLEASE HELP!! -ACID Product Family - MAGIX Community Forums Archive

Subject:PLEASE HELP!! Posted by: buckaroo Date:9/20/2003 5:41:04 AM I am using a Samtron 70E 17" monitor fine, & added a 2nd Monitor (Compaq 7500 17" Monitor) on my ATI Radeon 7000 series dual graphics card. I then run Acid 4.0e on one monitor and FL.4 (as a VSTi) on the other which was set-up fine - When i go to open Acid now it loads FL.4 and doesnt "draw" the 2nd screen properly - Also when i start to move the Mouse it comes up with: "Not enough Storage space is suitable to process for this command" Then it doesnt re-draw properly and hangs! - I also get the messge : "Access Violation at address 045B3E60 in module FL ENGINE.dll read of address BEEA75E2" PLEASE HELP - i have used the 2 monitors for Acid Rewired to Reason 2 and that seemed ok - Whats happening? i have a p4 2.4 with 1024mb RAM 120gb/80gb HD's etc so it should be up to it - & in the corner it only says its used about 30/1024mb of RAM! Is it the monitor? - (its plug & play) it seems to work fine on 1 monitor - underneath ACid...
Subject:RE: PLEASE HELP!! Reply by: Iacobus Date:9/20/2003 1:16:45 PM If it works OK with Reason but not with Fruity, maybe something is getting lost in the translation between Fruityloops and the Radeon? Did you pick up the latest version of the CATALYST drivers over at ATI? Is there an update for Fruityloops as well? HTH, Iacobus ------- RodelWorks - Original Music for the Unafraid mD's ACIDplanet Page

I am using a Samtron 70E 17" monitor fine, & added a 2nd Monitor (Compaq 7500 17" Monitor) on my ATI Radeon 7000 series dual graphics card.

I then run Acid 4.0e on one monitor and FL.4 (as a VSTi) on the other which was set-up fine - When i go to open Acid now it loads FL.4 and doesnt "draw" the 2nd screen properly - Also when i start to move the Mouse it comes up with:

"Not enough Storage space is suitable to process for this command"

Then it doesnt re-draw properly and hangs! - I also get the messge :

"Access Violation at address 045B3E60 in module FL ENGINE.dll read of address BEEA75E2"

PLEASE HELP - i have used the 2 monitors for Acid Rewired to Reason 2 and that seemed ok -

Whats happening? i have a p4 2.4 with 1024mb RAM 120gb/80gb HD's etc so it should be up to it - & in the corner it only says its used about
30/1024mb of RAM!

Is it the monitor? - (its plug & play) it seems to work fine on 1 monitor - underneath ACid...