making more than 1 CDR

brokenrecords wrote on 11/17/2002, 6:47 PM

Anyone else experience this?
I burn one CD and want to burn another..
I take the completed CDR out, place another blank CDR in, click YES, the new CD goes in, it starts the process, stops, then spits the CD back out asking for a fresh CD.. I push the tray back in with the same CD, click YES again and it starts to burn.

Any idea why it would be doing this?

Comments

Geoff_Wood wrote on 11/18/2002, 5:18 AM

It has done this a fews times to me too - did you log the fault to SF ? I've been too busy ...

geoff

brokenrecords wrote on 11/20/2002, 9:39 AM

anyone from Sonic Foundry able to give me a clue as to why this would be happening?
Thanks!

SonyDennis wrote on 11/20/2002, 1:43 PM

I'm not sure why this would happen. Perhaps it's a timing issue with the "disc insert" notification message from Windows.
///d@

themuzic wrote on 11/21/2002, 7:47 AM

What I have found is if you click yes almost right after the drawer closes it will do this. It stopped doing it completly to me when I started waiting a few seconds after the drawer closed. I usually now wait till the drive light goes out.

Hope this helps.

Johnny

brokenrecords wrote on 11/23/2002, 11:38 PM

I tried that as well, but it still spits the CDR out... I have to push it back in and click yes again, and then it starts to burn. Strange.

brokenrecords wrote on 11/29/2002, 10:01 PM

Seems to work fine if I enable Eject CD after completed....
I think I found my answer.

freendeed wrote on 11/30/2002, 3:58 AM

Do you have auto-insert notification on in Windows? Do yo have and Direct CD type software running?